Parabody Leg Press 100101 Instrukcja Użytkownika

100101 LEG PRESSCLASS HPART# 7037301REV. BVersion: 100101Revision: 06/21/011ASSEMBLY INSTRUCTIONSWARNING:Read and follow all directionsfor each step

10FIGURE 8STEP 8:• SECURELY assemble the FOOT PLATE (4) to the LEVER TUBES (5) using two 1/2 X 6-1/2” BOLTS (28) and two 1/2” LOWHEIGHT LOCK NUTS (2

FIGURE 9STEP 9:11 27 1/2 X 3-1/4” 221 5• SECURELY assemble the SEAT FRAME (2) to the LEVER TUBES (5) using two 1/2 X 3-1/4” BOLTS (27) and two 1/2”

STEP 10:FIGURE 1001234561/2 1/2 1/2 1/2 1/2 1/2• SECURELY assemble the SEAT PAD (8) to the HANDLE (6) and the SEAT FRAME (2) using two 3/8 X 1-1/2”

13STEP 11:FIGURE 11• SECURELY assemble the SEAT PAD (8) to the SEAT FRAME (2) using two 3/8 X 2-3/4” BOLTS (24) and two 3/8” LOCKWASHERS (18) as sho

14STEP 12:FIGURE 1201234561/2 1/2 1/2 1/2 1/2 1/2• To adjust the SEAT, sit in the LEG PRESS, gently press against the FOOT PLATE and pull back on t

IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the Parabody 100101 LEG PRESS. Please read these instructionsthorough

3PARTS LISTPART #65745086573608665570865754086573908647640865751026597421657400131031023116201617700164052016416601646700165006013102501KEY12345678910

4FIGURE 1STEP 1:• SECURELY assemble the REAR TUBE (3) to the BASE FRAME (1) using two 3/8 X 3” BOLTS (25), four 3/8” FLAT WASHERS(17), and two 3/8”

FIGURE 2STEP 2:• SECURELY assemble one 3/8” SPRING PIN (33) to the spring pin barrel on the SEAT FRAME (2) as shown in FIGURE 2.• Insert two 2” SQ

6STEP 3:FIGURE 301234561/2 1/2 1/2 1/2 1/2 1/2• Attach four PARAGLIDE STRIPS (14) to the outside of the ADJUSTMENT TUBE (7) using the following step

7STEP 4:FIGURE 4• CAREFULLEY slide the ADJUSTMENT TUBE (7) over into the SEAT FRAME (2) and engage the SPRING PIN into one ofthe adjustment holes. S

8STEP 6:FIGURE 617 55/16” SET SCREW 3201234561/2 1/2 1/2 1/2 1/2 1/2 1 9• SECURELY assemble the LEVER TUBES (5) to the BASE FRAME (1) using two 3/4”

9STEP 7:FIGURE 7 130 5 413• Insert four 2” SQ. END CAPS (13) into the ends of FOOT PLATE (4) as shown in FIGURE 7.• Insert eight 1/2” FLANGE BEAR